900 L4-2118cc 2.1L DOHC (1992)
Constant Velocity Joint: Service and Repair
Inner CV Joint
Inner Joint Driver Removal and Installation
Refer to Differential,Manual Transaxle for removal and installation procedures of the Inner CV Joint Driver. See: Manual
Transmission/Transaxle/Differential/Service and Repair
Inner CV Joint Disassembly and Assembly
To Dismantle
1
Remove the grease from the joint.
2
Remove the circlip.
Note: The latest drive-shaft variants incorporate a stop for the driver cup instead of a circlip. This comprises a taper on the shaft and a
corresponding taper on the driver-cup splines.
The latest variant of the driver cup must be fitted to drive shafts of the latest variant. However, the new driver cup may also be fitted to
early-variant drive shafts.
New drive shafts are filled in production to the following cars:
-
Cars to Scandinavian specification with effect from chassis nos.:
AC1022347, AC2007941, AC3007195 and AC6OO1952.
-
Cars to non-Scandinavian specifications with effect from chassis nos.:
AC1005904 AC2001784, AC3001770 and AC6OOOOO1.