900 L4-2118cc 2.1L DOHC (1992)
9. Fit the 3rd / 4th gear synchromesh hub. Fit the 3rd / 4th selector fork to the 3rd / 4th synchromesh sleeve and fit these onto the synchromesh hub.
Fit the sleeve for 4th gearwheel. Fit the gearwheel onto the sleeve. Fit the sleeve for the ball bearing.
10. If the selector rod has been removed refit it together with the guide pin of the selector interlock device.
11. Move the synchromesh sleeves on the output shaft to the neutral position and fit the selector shafts for 1st / 2nd and 3rd / 4th selector forks.
12. Fit the actuator for 5th gear to the reverse gear selector shaft.
13. Fit the needle bearing into the rear layshaft pinion set and fit it into the gearcase.
