900 L4-2118cc 2.1L DOHC (1992)
23. Fit the reverse gear and shaft. Make sure that the pivoted segment of the reverse gear lever engages into the groove in the reverse gear. Use tool 83
90 049 to adjust the shaft to the proper locking position.
24. Apply Loctite 242 to the locking plate bolt.
Tightening torque: 23 - 28 Nm (17 - 21lb ft).
Fit the locking plate to secure the shafts.
25. Fit the primary drive chains and sprockets. Check that the locking holes of the bottom sprocket face out towards the nut side.
26. Fit the chain tensioner. Apply Loctite 45 to the mounting bolts and tighten them to a torque of 23 - 28 Nm (17 - 21 lb ft).