9000 L4-1985cc 2.0L DOHC (1986)
Alarm Wiring Harness
Window Decals (2)
Water-proofed hex head blunt tip sheet metal screws, qty 2 (module bracket)
Plug connector (LED lead)
Machine screws, qty 2 (module to bracket)
Additional parts required (1990 Convertible models only):
8-pin Connector Housing
P/N 91 24 090
Female pins (qty 6)
P/N 91 20 775
P/N 02 16 028
(not included in early kits)
To replace a Saab Guard Installation equipped with the remote disarm accessory, the complete Alpine Accessory Alarm kit (02 46 538) can be used with
the following installation procedure as an addendum to the complete kit instructons. It is also possible to add remote control operation to the replacement
module kit by adding the following parts:
Remote Transmitters (qty 2)
P/N 02 46 165
Transmitter pouches (qty 2)
P/N 02 46 215
P/N 02 46 280
3-ROM chip kit
P/N 02 46 322
Installation Procedure, 1985-90 900
Remove the original "Saab Guard" module from under the rear seat. If the module was fastened to the floor using screws, reinstall the screws to
seal the holes.
Remove access cover from alarm module. Set switch 1 to active (on/up position) or passive (down position) arming per customer's requirements.
Set switch 2 to the same position as switch 1 (Figure 1).
To control the alarm with the igniton key, set the switches to "Passive." If the customer chooses to use the optional remote transmitters, set the
switches to "Active."