9000 L4-1985cc 2.0L DOHC (1986)
4.
Connect the wire from terminal no. 1 of the pictogram to terminal A on the delay relay. Connect the wire from terminal C1 of the pictogram relay
to terminal B of the delay relay.
5.
Drill a 4 mm hole at the edge of the relay panel (Figure 1) and mount the relay from the service kit using the nut and bolt. Be sure there is some
slack in the wires.
6.
Refit the relay panel and glove compartment and move on to the rear taillights.
7.
Remove the plastic cover over the right taillight.
Check to see if the car has been previously modified (see S.I. 01/87- 927). If not, proceed to step 8.
FIGURE 2
8.
Cut the black wire (189A 1.0 M86/1.5 M87) at the right taillight as close to the harness sheathing as possible (Figure 2). Leave enough wire to
reach the new ground point.
9.
Attach a ring terminal to the black wire.
FIGURE 3
