9000 L4-1985cc 2.0L DOHC (1986)
Band: Adjustments
PUSHROD FOR ADJUSTING BRAKE BAND C
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
Adjusting/Fitting
1. Install the O-ring on the dowel and install dowel in housing.
-
Some versions have two O-rings.
2. Screw in the adjusting screw.
-
Tightening torque: 10 Nm (88 inch lbs.)
IMPORTANT: While tightening, cylinder B should be turned. Otherwise, there is a danger of the brake band becoming misaligned.