9000 L4-1985cc 2.0L DOHC Turbo EFI (1987)
14. Reverse the insert in the press tool and position it with the V-notch straight above one of the pins of the link. Using the press tool, peen over the
end of the pins using a force of 15 Nm (11 ft lb). Repeat on the other pin of the link.
15. Check the riveting by using a micrometer to measure the diameter of the chain link pins. The correct measurement is 3.4-3.6 mm (See Figure 9).
Remove the protective cloth. Remove the chain support, and if previously removed, fit the oil pipe (where applicable) connected to the cylinder
head.