9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
Engine Mount: Service and Repair
Rear Mount
REMOVAL
1. Lift the power steering servo oil reservoir and release both ends of the torque arm.
2. Remove the bolt between the right-hand engine suspension and the engine mounting.
3. Remove the bolt between the rear right-hand engine pad and the engine mounting.
4. Raise the car and position a high-lift jack under the engine.
5. Raise the engine and remove the rear engine pad.
INSTALLATION
1. Align the engine pad and tighten it onto the subframe.
2. Lower the engine and remove the jack.
3. Lower the car and tighten the bolts to 39 Nm (29 ft. lbs.) between the engine pads and the engine mountings.
4. Fit the torque arm and press the power steering servo oil holder into its clip.