9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
To Install
1
Press the blended air temperature sensor leads into the connector.
2
Install the damper motor mounting and the blended air temperature sensor in position. Tighten the three securing screws.
3
Plug in the connector in the damper motor mounting. Install a cable tie around the lead and the mounting.
4
Press in the blended air temperature sensor. Install the control cable and the clip.
5
Attach the right-hand defroster duct.
6
Attach the right-hand side defroster duct.
7
Install the right-hand air duct and fix it using a cable tie.
8
Reinstall the electrical distribution box and the glove compartment (or the main instrument and the upper part of the facia).
9
Calibrate the ACC control module by pressing the "AUTO" and "VENT" buttons at the same time.
Important : During calibration, all previously stored diagnostic trouble codes are erased. Before carrying out calibration, all stored diagnostic trouble
codes should be read.
Servomotor, Air Recirculation Flap, Changing