saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 6959 > < Diagram Information and Instructions|Page 6957
Page 2
background image

Fuel Gauge: Component ID

COMPONENT ID

16

Rheostat, lighting for controls, on dashboard between the steering wheel and driver's door.

23

Relay, direction indicators, in main fuse box behind the glove box.

46

Fuel level sensor, in fuel tank under the luggage compartment floor.

In The Main Instrument Display Panel

18

Lighting for instruments.

47A

Fuel gauge

47B

Indicator lamp for low fuel level.

47C

Coolant temperature gauge.

47I

Indicator lamp, right-hand direction indicators.

110

Tachometer (rev counter).

210

EDU trip computer in the main instrument display panel.

289

Anti-theft alarm control module, under dashboard on the right-hand side behind the knee shield. 

4-Pin Connector

H4-4

Beside the fuel pump under the luggage compartment floor.

Grounding  Points

G8

Grounding point, dashboard, by the left-hand front loudspeaker socket.

DESCRIPTION OF OPERATION

Fuel Level Sensor 46
The fuel level sensor is integrated into the fuel pump.

Fuel Gauge 47A
When the ignition switch is in the Drive position, 12 V is supplied to pin 2 of the temperature instrument from pin 22 of EDU 210. Fuel level
sensor 46 is connected to the EDU which, after processing the information, sends a 1-9 V signal to pin 1 of the tank/temperature unit.

1 V = tank empty
9 V = tank full.

Temperature gauge 47C, fuel gauge 47A, instrument lighting lamps 18, and indicator lamp 47I are connected to ground via pin 5.

Instrument Lighting 18
Backlighting of the instruments is controlled by rheostat 16 (lighting for controls) via pin 6.

Indicator Lamp 47I
The indicator lamp for the right-hand direction indicators is controlled by flasher relay 23 via pin 4.

Pilot Lamp 47B
Fuel warning lamp 47B is controlled by EDU 210. When the fuel level in the tank drops below 10I, the lamp is grounded via pin 3.

FAULT DIAGNOSIS HINTS

Fuel Gauge
The fuel gauge is activated when the ignition switch is turned to the Drive position.

1. Check that current is supplied to pin 2.

Diagram Information and Instructions|Page 6959 > < Diagram Information and Instructions|Page 6957