9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
Belt Tensioner, Passenger Side
14. Fold the carpet away from the bulkhead partition on the passenger side.
15. Run the wiring (one blue/white and one yellow/white lead), along the bulkhead partition, up to the cable channel by the wheel housing. Tape the
wiring to the bulkhead partition.
16. Fit the new wiring in the cable channel together with existing wiring.
17. Undo the bolt securing the belt roller and belt tensioner.
18. Run the wiring behind the belt tensioner together with existing wiring.
19. Plug in the connector to the belt tensioner.
20. Tie the wiring to existing wiring using cable ties.
WARNING: The wiring must not come into contact with moving parts like the belt tensioner and belt.
Fuse
21. Run the fuse lead (green/white) along existing wiring as far as the fuse holder. Tie the lead to existing wiring and the air vent above the SRS
control module using cable ties.
22. Remove fuse 4 from the fuse holder.
Connect a buzzer between sleeve 5 in the SRS connector and the sleeves in fuse 4. The buzzer sounds when it is connected to one of the sleeves in
the fuse holder. Remove the sleeve that "buzzes".
23. Cut the sleeve from the lead and insulate the lead.
24. Connect the new sleeve on the spare cable assembly to the fuse.
25. Refit fuse 4.