9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
Data link connector
26
Pull out sleeve 9 in the rejected SRS connector and cut the lead at the sleeve. Cut as near the sleeve as possible.
27
Thread shrink tubing over the lead trom sleeve 9 in the new SRS connector.
28
Solder together the lead from sleeve 9 in the new SRS connector and the cut lead in the rejected SflS cable assembly.
First cut the lead to appropriate length.
29
Slide on the shrink tube and heat. Attach the shrink tube to the cable assembly on both sides of the shrink tube so that it cannot bend. Use tape or
cable ties.
30
Tape up the rejected connector.
31
Plug the SRS connector into the SRS control module.
Instrument
32
Run the blue lead along the air duct over the pedal bracket. Secure using cable ties.