9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
Clutch: Service and Repair
1st One-Way Clutch
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
Removal
1. The one-way clutch inner-ring can be pressed out of the complete unit.
2. Pry off the circlip from the one-way clutch outer ring.
3. Remove the Belleville washer and one-way clutch.
-
Be careful that the one-way clutch does not fall apart.
Check
-
Check that the springs are still tensioned and push out the rollers fully.
Installation
1. Place the one-way clutch outer ring on a suitable surface.
2. Press the one-way clutch inner ring into the outer ring.
3. Carefully align the one-way clutch holder and install it into place, pressing the rollers slightly outwards.
4. Then turn the one-way clutch carrier so that the metal edge can be pressed into the track in the outer ring.
5. Place the holder ring in such a way that the three installing marks have the round part facing up, and fix using the circlip. Install one end of the
circlip into the groove and then use a screwdriver to press the rest of the circlip into the groove (the holder ring must be centered).