9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
Clutch: Service and Repair
Clutch A
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
Disassembly
1. Remove the circlip using suitable pliers.
2. Withdraw the turbine shaft towards the drive side.
3. Remove the circlip from the cylinder and withdraw the entire plate assembly, including the spring plate.
4. Press down the holder plate in a press with tool No. 87 91 535 and remove the circlip using pliers tool No. 87 90 180, or equivalents and a
screwdriver.
5. Remove the holder plate and the two Belleville washers under it by tapping it lightly against the workbench.
6. Install a compressed air gun to one of the two fluid supply passages, cover the two open fluid supply passages and press out plunger A using the
compressed air.