9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
Installation
1. Press the ball bearing onto the righthand drive shaft in a press using press tube tool No. 78 41 067, or equivalent, and secure using the circlip.
2. Using driver tube tool No. 87 91 311, or equivalent, press in the drive shaft together with the bearing and shaft seal.
3. Install the circlip for the drive shaft and the O-ring.
Inner Driver, LH Side
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
CAUTION:
^
Automatic transmissions, including the driver, are extremely sensitive to contamination.
^
The smallest amount of dirt can cause reduced performance or transmission breakdown.
^
It is therefore extremely important that the transmission is clean and that other parts are carefully cleaned before removal and installing.
Removal
1. If the transmission has not been removed from the car: