9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
Installation
1. Carefully tap in the bushes using the driver tool
NOTE: The reverse selector shaft has no bush in the gear case.
Sinter Insert (Venting)
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
Removal
1. From outside tap the sintered insert out of the gear case with a suitable drift.
Installation
1. Carefully tap in a new sintered insert from the parting surface side (the sintered insert is conical).
CAUTION:
^
Use a hollow drift or a piece of pipe, so that the surface of the sintered insert is not pressed together (blocked).
^
If the sinter insert is blocked, its venting characteristics are destroyed and the oil in the gearbox could be forced out.