9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
35. Check that fourth gear is engaged.
-
Install the fifth gear's pinion, baulk ring and synchromesh hub.
-
The stop heels of the baulk ring should be placed opposite the holes in the hub.
-
It might be necessary to tap down the hub with sleeve tube tool and a plastic hammer.
36. Install the fifth gear's fork on its sleeve.
-
Install fork and sleeve.
-
The sleeve should be installed with the high heels against the synchromesh hub's deep teeth gaps.
-
Install a new locking ring.
37. Hammer in the clamping pin in the gear change shaft.
38. Remove the cover over the gear case's holes.
-
Install a new gasket and the end cover.
-
Tighten the screws to 20-28 Nm (15-21 ft. lbs.).
39. Test the gear change mechanism by engaging all gears one by one.