9000 CS L4-2290cc 2.3L DOHC Turbo EFI (1996)
INSTALLATION
1. Position the spring with rubber cup on the link arm.
IMPORTANT: Check the rubber cup and the springs position on the link arm. The top of the rubber should sit in the small hole in the link arm.
2. Lift up the link arm with the jack and check the spring arrives at the correct position.
3. Fit the rear mounting of the link arm and tightening to 52 Nm (38 ft. lbs.)
4. Fit the parking brake wire and the ABS cable, if necessary, on the link arm.
5. Replace the wheel and lower the car.
6. Tighten the wheel studs to 120 Nm (89 ft. lbs.)
