9000 CSE L4-2290cc 2.3L DOHC Turbo EFI (1995)
Action:
Cars with ACC:
1. Remove the rubber seal and cover panel over the bulkhead partition space.
Disconnect the washer fluid hose.
2. Remove the right-hand screening panel.
WARNING!
The fan control's heat sink is live until the connector is unplugged.
3. Unplug the fan control connector and remove the three retaining screws.
Lift out the control.
4. Fit the new fan control and three retaining screws. Plug in the connector.
5. Check the fan's current consumption as described below.
6. Refit the screening panel.
7. Reconnect the washer fluid hose to the cover panel and refit the panel and rubber seal over the bulkhead partition space.
Important
On calibration, all previous diagnostic trouble codes (DTC's) will be cleared. Obtain readouts of all stored
DTC's before starting calibration.
8. Calibrate the ACC system by pressing the "AUTO" and "VENT" buttons simultaneously, or by using SAT.
