9000 CSE L4-2290cc 2.3L DOHC Turbo EFI (1995)
8. Lower the car.
9. Remove the hose for the crankcase ventilation from the camshaft cover.
10. Remove the lifting eye.
-
Remove the ground connection in the cylinder head and move the lifting eye there.
11. Remove the torque arm bracket.
12. Remove front exhaust pipe.
13. Install the lifting beam, place the lifting hook in the lifting eye and lift the drive unit enough to be able to remove the support bearing bracket.
14. Lift the car.
15. Remove the screw which holds the engine mounting in the support bearing bracket.
16. Remove the bottom securing screws for the support bearing bracket.
-
The securing screws also secure a bracket on which the oxygen sensor's connector and the clamp for the pipe to the servo pump are installed.
17. Remove the upper securing screw of the support bearing bracket.
