saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 5518 > < Diagram Information and Instructions|Page 5516
Page 4
background image

230

Distribution terminal (+30 circuit) in main fuse box behind the glove box.

242

Coolant level switch in the coolant expansion tank.

245

EDU transmission range switch (automatic transmission) beside the selector lever.

286

Outside temperature sensor, on the left-hand side behind the front spoiler.

445 (H16-1)

Diagnostics test socket, below the steering wheel.

430

Saab Trionic control module in the engine bay on the left behind the bulkhead partition.

510

Motronic M2.8.1 control module, in the engine bay behind the bulkhead partition.

587

Motronic M5.2 control module, on a bracket under the dashboard.

589

Saab Trionic OBDII control module, in the engine bay on the left behind the bulkhead partition.

2-Pin Connector

H2-1

Beside the coolant expansion tank.

3-Pin Connector

H3-20

Behind the main instrument display panel beside the speedometer (ME).

4-Pin Connector

H4-4

Beside the fuel pump under the luggage compartment floor.

10-Pin Connectors

H10-15

Behind the left-hand headlamp.

H10-25

Behind the left-hand headlamp.

24-Pin Connector

H24-2

Behind the left-hand headlamp.

70-Pin Connector

H70-1

In the engine bay, behind the bulkhead partition.

Grounding Points

G8

Grounding point, dashboard, by the left-hand front loudspeaker socket.

G14

Grounding point, left-hand seat member, under the left-hand front seat.

G31

Grounding point, right-hand structural member, behind the right-hand headlamp.

DESCRIPTION OF OPERATION

EDU 3 Trip Computer And Clock: Cars With A Manual Gearbox

Cars With A Manual Gearbox

EDU 3 Trip Computer And Clock: Cars With Automatic Transmission

Cars With Automatic Transmission

General
The Electronic Display Unit (EDU) 3 trip computer is available in two basic versions, one for a manual gearbox and one for automatic
transmission. The computer is programmable, which means that a replacement trip computer must be programmed for the car model, etc. in which
it is fitted.

Diagram Information and Instructions|Page 5518 > < Diagram Information and Instructions|Page 5516