9000 CSE V6-2962cc 3.0L DOHC (B308) (1996)
5. Connect a length of transparent plastic tubing to the bleed nipple on the rear wheel's brake caliper (either rear wheel).
-
Place the other end of the tubing in a suitable receptacle.
6. Get a helper to switch on the ignition and depress the brake pedal.
WARNING
-
The high-pressure pump's electric motor should not be run for more than 2 minutes at a time.
-
It should then be allowed to cool down for 10 minutes.
7. Open the nipple until about 0.1 liters of brake fluid has been drained off.
-
To drain the same brake circuit for the other rear wheel: repeat points 5, 6 and 7.
8. Top up with brake fluid to the MAX mark on the brake fluid reservoir.