9000 CSE V6-2962cc 3.0L DOHC (B308) (1996)
CS: in tailgate light fitting.
44
Oil pressure sensor 2.0 I, T: on upper part of oil filter housing to the right at the rear of the engine. 2.3 I, T: on the engine block
at front of engine.
In Pictogram 213
47d
Oil pressure warning lamp
47t
SRS warning lamp
159
Distribution terminal (+15 circuit), in main fuse box behind the glove box.
In Pictogram 213
213a
Central warning lamp
213b
Indication, rear lights
213c
Indication, front lights
213h (47d)
Oil pressure warning lamp
213i (47t)
SRS warning lamp
228a
Filament monitor, rear lamps, in luggage compartment on the left-hand side.
228b
Filament monitor, front lamps, in main fuse box in front of the battery.
331
SRS control module, in front part of the centre console under the dashboard.
342a
Fuse board in main fuse box in front of battery.
4-Pin Connector
H4-21
Beside the generator (V6).
8-Pin Connector
H8-4
By the left-hand rear wheel housing.
24-Pin Connector
H24-2
Behind the left-hand headlamp.
70-Pin Connector
H70-1
In the engine bay, behind the bulkhead partition.
Grounding Points
G3
Grounding point, luggage compartment, beside the left-hand rear light cluster.
G5
Grounding point, under the rear seat on the left.
G8
Grounding point, dashboard, by the left-hand front loudspeaker socket.
G29
Luggage compartment grounding point, right-hand, beside the right-hand rear light cluster.
G30
Grounding point, on left-hand structural member behind the left-hand headlamp.
G31
Grounding point, on the right-hand structural member behind the right- hand headlamp.
DESCRIPTION OF OPERATION
Certain parts of the car's lighting system are monitored by two filament monitors, 228a and 228b, and pictogram 213.
The five lamps f, g, d, e and j in the pictogram are covered individually in the Pictogram - Door Indication.
Filament Monitors
Filament monitor 228b monitors headlamp main and dipped beams and filament monitor 228a monitors rear lights and brake lights.
Filament monitor 228b incorporates relays which act on the pictogram and light lamp c if a failure occurs while filament monitor 228a
incorporates shunt resistors which act on the pictogram and light lamp b if a failure occurs.
The lamp in the centre, a (central warning lamp), lights up the car's outline on the pictogram and always comes on when a failure is detected.
When ignition switch 20 is in the Drive position, current is supplied to pictogram terminal 5.
Front Filament Monitor 228b
If there is a fault in any lighting circuit, an imbalance arises and the relay is activated. Terminal C2 in the filament monitor and lamps C and A
(central warning lamp) in the pictogram are grounded and the lamps light up.
Rear Filament Monitor 228a
The filament monitor senses if the current to one of the lamps is incorrect. Terminal C1 in the filament monitor and lamps b and a (central warning
lamp) in the pictogram are grounded and the lamps light up.
The filament monitor incorporates a circuit for monitoring brake lights switch 29 and the high-level brake light, refer to Brake Lights.
Oil Pressure Warning Lamp 47d