9000 CSE V6-2962cc 3.0L DOHC (B308) (1996)
1. Undo the connector from the Electronic Control Unit (ECU).
2. Connect the breakout box to the connector of the control module.
-
Connect wiring looms 1 (pins 1, 34 and 35) and 2 (pins 18, 36, 21 and 2) (part No. 86 11 212).
-
Connect pin 1 when the ignition is switched on.
-
Run the pump for one minute.
-
Connect the crocodile clip twenty seconds after the pump has started up so that the outlet valves are opened.
-
Disconnect the crocodile clip after a further twenty seconds.
-
Disconnect pin 1 sixty seconds after the pump has started up.
-
Switch off the ignition.
3. Connect the bleed hose to the bleed valve.
-
Ask someone to help by pressing the brake pedal at least ten times per brake caliper until brake fluid free of air bubbles is visible through the
transparent hose.
-
Check the fluid level in the brake fluid reservoir to make sure the reservoir is not drained.
-
Bleeding will not be possible until the bleed nipple has been opened.