900 S Convertible L4-2290cc 2.3L DOHC EFI (1997)
Important
The ambient temperature must be at least 20°C (68 °F) when gluing the electrically heated rear window connecting tab due to the curing time of the
adhesive.
1
Operate the soft top so that the fifth bow rises.
2
Remove the connector from the connecting tab.
3
Carefully remove as much of the old solder from the window as possible without damaging the plating (the conductive material). Use a sharp
knife. Smooth off the surface of the window connecting points to make them level.
4
Rub the surface where the new connecting tab is to be fitted with the abrasive cloth (P1200).
5
Clean the new connecting tab and the window with cleaner, Teroson FL 875 (part no. 30 15 815). Clean also the surface on which the adhesive is
to be mixed so that it is not contaminated with foreign substances.
6
Squeeze out about 1/2" (1.5 cm) of each tube, "Part A" and "Part B". Mix thoroughly.