900 S Coupe L4-1985cc 2.0L DOHC Turbo EFI (1998)
Installation
1. Plug in the connector and mount the sensor on the shaft.
2. Install the gear selector position sensor's nut.
-
Tightening torque: 8 Nm (72 inch lbs.) .
3. Install the lever but do not tighten it and move the selector lever to position N.
-
Lift off the lever and check the position of the gear selector position sensor.
4. Tighten the bolt(s).
-
Tightening torque: 25 Nm (18.5 ft. lbs.) .
5. Check that the engine starts with the selector lever in positions P and N and that the reversing light comes on only in position R.
6. Clean and lubricate the fluid filler pipe's O-ring with acid free Vaseline (petroleum jelly) and install the fluid filler pipe.
-
Tightening torque: 25 Nm (18.5 ft. lbs.) .
7. Install the servo pump pipe's mounting bracket.
8. Install the battery.