900 S Coupe L4-1985cc 2.0L DOHC Turbo EFI (1998)
Gear Selector Position Sensor: Service and Repair
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
Removal
1. Move the selector lever to position P.
2. Remove the battery.
3. Remove the dipstick.
4. Remove the servo pump pipe's mounting bracket to expose the gear selector position sensor.
5. Remove the lever.
6. Remove the gear selector position sensor's bolt.
7. Remove the gear selector position sensor's nut.
8. Unplug the electrical connector and lift the sensor off the shaft.