900 S Coupe L4-1985cc 2.0L DOHC Turbo EFI (1998)
Installation
1. Press on the sealing ring until it makes contact using tools 87 90 859, 83 90 312 and support 87 92 236.
-
Fill the sealing ring with Shell Grease 1344 LIEP II.
2. Install the seal holder with the four screws. Check that the 0-ring is in place. Tighten alternately to 20-24 Nm (14.5-17.5 ft. lbs.)
Support Sleeve
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
REPLACEMENT
NOTE: Precondition: clutch shaft and arm removed.
1. Remove the three screws and remove the support sleeve.
-
Put the three screws in a safe place.
2. Fill the sealing ring with grease, Shell Grease LIEP II, or equivalent lubricant.
3. Install a new support sleeve.
4. Install the three screws with thread sealing agent.
Tightening torque: 10-14 Nm (84-120 inch lbs.)