900 S Coupe L4-1985cc 2.0L DOHC Turbo EFI (1998)
Installation
-
Carefully tap in the bushes using driver tool.
NOTE: The reverse selector shaft has no bush in the gear case.
Sinter Insert (Venting)
Removal
1. From outside tap the sinter insert out of the gear case with a drift.
Installation
-
Carefully tap in a new sinter insert from the parting surface (the sinter insert is conical).
CAUTION:
-
Use a hollow drift or a piece of pipe, so that the sinter insert is not pressed together (blocked).
-
If the sinter insert is blocked, its venting characteristics are destroyed and the oil in the gearbox could be forced out.
In Left Seal Holder