900 SE Hatchback L4-1985cc 2.0L DOHC Turbo EFI (1997)
To Remove
1. Open the drain plug and drain out the coolant. Remove the lid of the expansion tank to speed up the draining.
2. Remove the air cleaner.
3. Undo the intake hose and plug the pipe (turbo).
4. Remove the bypass hose and remove the pressure pipe between the charge air cooler and the throttle body (turbo).
5. Release the tension on the belt tensioner with an extension to a ratchet and install a 6 mm drill in the hole, see illustration.
6. Undo the steering servo pump with its console and hang it up on the radiator crossmember.
7. Undo the coolant hoses and the pipes on the pump.
8. Undo the screw which holds the coolant pipe to the front left-hand corner of the engine.
9. Remove the hose to the throttle body from the coolant pipe and undo the screws on the thermostat housing. Move the pipes to one side.
10. Remove the boost pressure control valve and move it to one side (turbo).
11. Remove the coolant pump.
12. Remove the sleeve with the 0-rings and remove the coolant pump from the pump housing.
