900 SE Hatchback L4-1985cc 2.0L DOHC Turbo EFI (1997)
INSTALLATION
1. Bolt the engine mounting to the gearbox, then tighten to: 39 Nm (29 lbs. ft).
2. Position the sub-frame and bolt it in place, then tighten as follows:
-
Front bolts:115 Nm (85 ft. lbs.).
-
Middle bolts:190 Nm (140.6 ft. lbs.).
-
Rear bolts: 110 Nm + 75° (81.4 ft. lbs. + 75°).
3. Install the nuts securing the engine mounting to the sub-frame and tighten them, then tighten to: 39 Nm (29 lbs. ft).
4. Install the nuts securing the end pieces and tighten them, then tighten to: 75 Nm (55.5 lbs. ft).
5. Clean the exhaust pipe joints.
6. Install the bolt securing the catalytic converter to the bracket on the engine but do not tighten it.
-
Bolt the front exhaust pipe to the turbocharger.
-
Before assembly, apply Molykote 1000, or equivalent, to the threads on the turbocharger studs.
7. Tighten the bolt securing the catalytic converter to its bracket on the engine and bolt together the joint under the car.
8. Install the spoiler sections and road wheels, then tighten the wheel bolts to 120 Nm (89 ft. lbs.).
9. Lower the car to the floor and plug in the oxygen (Lambda) sensor connector.
-
Install the cable clamp and clip.
10. Remove the lifting beam.
