900 SE Hatchback L4-1985cc 2.0L DOHC Turbo EFI (1997)
10. Prepare the chain tensioner for fitting by pressing down the catch and pushing in the chain tensioner.
11. Install the chain tensioner, using a 27 mm socket, then tighten to: 63 Nm (47 ft. lbs.).
12. Install the plug for the chain tensioner with push rod and spring and tighten to: 22 Nm (16 ft. lbs.).
13. Check that the chain is correctly seated in the guides.
-
Rotate the crankshaft two complete turns and check that the timing marks on the flywheel and camshafts are still in alignment.
-
Tighten the camshaft sprocket bolts to: 63 Nm (47 ft. lbs.).
14. Clean the flanges of the camshaft cover, using a suitable solvent.
15. Apply soap to the open end of the camshaft cover and install the cover, starting at the open end.
-
Then continue all the way round, on both the inside and outside.
-
Tighten cover bolt to: 15 Nm (11 ft. lbs.).
16. Install the nipple for crankcase ventilation and vacuum to the camshaft cover and install the bolt for the crankcase breather pipe to the camshaft
cover.
17. Install the ignition discharge module or ignition cables and the cover plate and tighten to: 11 Nm (8 ft. lbs.).
18. Reconnect the ignition discharge module leads.
