900 SE Hatchback L4-1985cc 2.0L DOHC Turbo EFI (1997)
3. Install the support sleeve.
-
Install and tighten the three screws with a thread-sealing agent.
-
Tightening torque: 10-14 Nm (84-120 inch lbs.).
CAUTION:
-
Do not forget the thread-sealing agent on the through screws on the support sleeve.
-
Risk of oil leakage.
Bearing Bush
Removal
-
Remove sealing ring and tap out the bearing bush with driver tool No. 87 91 220, or equivalent.
Installation
-
Install a new bearing bush with driver tool No. 87 91 220, or equivalent.
Differential Bearing Race
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
