saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Canister Purge Valve - MIL ON/DTC's Set|Page 5477 > < Canister Purge Valve - MIL ON/DTC's Set|Page 5471
Page 1
background image

Canister Purge Solenoid: Customer Interest
Canister Purge Valve - MIL ON/DTC's Set

CATEGORY: Electrical

SECTION: 3

PAGE: 77

ISSUE: 10/95

CODE: 371

Subject:
Harness Connector to Canister

Purge Valve Difficult to Fit

Application:
1992-94 900 Models

Intermittent illumination of the Malfunction Indicator Lamp (MIL) [CHECK ENGINE lamp] can occur due to the harness connector not being properly
connected to the canister purge valve. The reason for this is that the locating lugs on the bottom of the cable connector interfere with the housing on the
canister purge valve. This causes the connector to cock to one side and not make positive contact. This problem will generate ISAT DTC's as follows:

LH DTC: 58372, 38372, 38322 58322, 38382, 58382
LH Flash Codes: 12223, 12241, 12244, 12111, 12112
Trionic DTC: P0171, P0172, P1443, P1444, P1445
Trionic Flash Codes: 7, 8

Cars Affected:

1992-1993 900 models up to VIN P2011368.

1994 900 models up to VIN R2015828.

Action:

1.

M1992-1993, 1994 convertible:
Locate the evaporative emission canister in the front left-hand wheel house.

M1994:
Locate the canister purge valve on the righthand strut tower.

Canister Purge Valve - MIL ON/DTC's Set|Page 5477 > < Canister Purge Valve - MIL ON/DTC's Set|Page 5471