900 Turbo Convertible L4-1985cc 2.0L DOHC Turbo EFI (1994)
Braid 1, between engine block and cross-member
1.
Remove the air intake resonating chamber.
2.
Fit the grounding braid between left-hand side of the engine block and the strut tower brace, as shown.
3.
Secure the braid to the throttle cable by means of a cable tie. The braid should be slack between the engine and the cable tie to allow for engine
movement.
4.
Refit the resonating chamber.
Braid 2, between A/C pipe and left-hand part of subframe
1.
Raise the car.
2.
Drill a hole with a 3.5 mm (5/32 in.) bit in the left-hand part of the subframe about 100 mm (4 in.) from the bend at the front, see illustration.
3.
Secure one end of the braid by means of a sheet metal screw.
4.
Seal with anti-corrosion agent.