Astra L4-1.8L (2009)
7. Remove the protective sleeves (2) for the front parking brake cable from the parking brake lever support plate.
8. Pull the front end of the parking brake cable out of the protective sleeve.
Installation Procedure
1. Pull the front end of the parking brake cable into the protective sleeve.
2. Install the protective sleeves (4) to the parking brake lever support plate.
Note:
*
Ensure that the T-piece at the front end of the parking brake cable is seated correctly in the parking brake cable compensator (arrow).
*
This avoids accidental displacement and releasing of the front of the parking brake cable. Ensure that the centre of the parking brake cable is
seated in the mountings (1).
3. Install the parking brake cables (2) into the parking brake cable compensator and twist by 90 degrees.
Push the protective sleeve for the front of the parking brake cables (4) in the direction of the parking brake cable compensator until it passes over
the bulges (3) on the parking brake cable.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the heat shields (7) of the mid muffler to the vehicle underbody (arrows).
Tighten the nuts to 2 Nm (18 lb in).
5. Install the front exhaust pipes (5) and the mid muffler (6). Refer to Mid Muffler Replacement (See: Engine, Cooling and Exhaust/Exhaust
System/Muffler/Service and Repair).
6. Install the front of the parking brake cable on to the parking brake lever.
7. Screw in the adjusting nut loosely.
8. Install the front floor console. Refer to Front Floor Console Replacement (See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair).
9. Adjust the parking brake lever path. Refer to Parking Brake Adjustment (See: Adjustments).
