Astra L4-1.8L (2009)
15. Remove the fan motor out of the fan housing.
16. Disconnect the wiring harness plug (1).
17. Remove the bolt (2).
18. Disconnect the wiring harness (arrows).
19. Remove the 3 bolts (3).
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the fan motor in the fan housing.
Tighten the 3 bolts to 3 Nm (26 lb in).
*
Install the wiring harness plug.
*
Install the bolt.
*
Connect the 2 wiring harnesses.
2. Install the fan housing to the radiator.
Tighten the 2 bolts to 5 Nm (44 lb in).
3. Connect the cooling module wiring harness plug.
4. Install the 3 coolant hoses.
5. Install the air cleaner outlet resonator. Refer to Air Cleaner Inlet Duct Replacement (See: Engine/Tune-up and Engine Performance Checks/Air
Cleaner Housing/Air Cleaner Fresh Air Duct/Hose/Service and Repair).
6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (See: Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair).
7. Raise the vehicle by its full height.
8. Install the compressor wiring harness to the fan housing.
Connect the cable ties.
9. Lower the vehicle by its full height.
10. Connect the battery.
Install the negative connection to the ground terminal.
Tighten the nut to 5 Nm (44 lb in).
11. For reprogramming procedures, refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
12. Close the hood.
