Astra L4-1.8L (2009)
*
Align KM-6173 at the frame.
*
Position the support bearing (1).
*
Journal (2) must sit in the mount at the cylinder block.
*
Tighten the 4 bolts.
3. Attach KM-6001-A (1).
*
Loosen the 3 bolts (arrows) in the adjusting rails.
*
Insert KM-6001-A .
*
The journals (2, 5) must sit in the guide holes of the frame.
Install the 3 bolts in the adjusting rails.
*
Tighten the 3 bolts.
*
Adjust the support bearings, front (4) and rear (3).
Note: The guide journals must be seated free from play in the support bearings.
*
Raise the support bearings up to the stop on the guide journals.
4. Lower the vehicle by its full height.