Astra L4-1.8L (2009)
7. Remove the front toothed belt cover (center).
Remove 2x from toothed belt cover (rear).
Installation Procedure
1. Install the front toothed belt cover (center).
Install 2x to toothed belt cover (rear).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the support for the engine damping block.
Tighten the 3 bolts to 55 Nm (40 lb ft).
3. Install the engine damping block.
*
Install to the support.
Tighten the 3 bolts to 55 Nm (40 lb ft).
*
Install to the side member.
Tighten the 3 bolts to 35 Nm (26 lb ft).
4. Raise the vehicle by its full height.
5. Remove KM-6173.
Remove the 4 bolts.
6. Remove KM-6001-A .
Loosen the 3 screwed connections.
7. Install the front toothed belt cover (lower). Refer to Timing Belt Lower Front Cover Replacement (See: ).
