Astra L4-1.8L (2009)
2. Disconnect the wiring harness plugs.
3. Remove the recirculation actuator (1).
*
Remove the 3 bolts.
*
Disconnect the wiring harness plug (2).
*
Release and disconnect the wiring harness plug.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: The recirculation actuator can only be fitted in one position and is self-calibrating.
1. Install the recirculation actuator.
Tighten the 3 bolts to 5 Nm (44 lb in).
2. Connect the wiring harness plug.
3. Install the I/P compartment.
4. Connect the wiring harness plug.
Tighten 4 bolts to 4 Nm (35 lb in).
Note: Only upon replacement of air inlet actuator.
5. Connect the battery.
6. For programming procedures, refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
7. Perform the function inspection.
