Astra L4-1.8L (2009)
Fuel Tank Pressure Sensor: Service and Repair
Fuel Tank Pressure Sensor Replacement
Special Tools
SA9805E /KM-796-A Fuel Line Separator
Removal Procedure
Note:
*
The fuel tank must be drained with a suitable, commercially-available fuel removal unit and suction hose - follow safety regulations and
national legislation. The fuel tank is fitted with a refill limit float valve. This is located on the filler neck in the fuel tank. To prevent damaging
the refill limit float valve, a suitable suction hose must be used.
*
In the presence of fuel vapors or escaping fuel - observe safety regulations and national legislation. Store drained fuel in a suitable, sealable
container.
1. Open the hood.
Warning: Refer to Battery Disconnect Warning (See: Starting and Charging/Battery/Service Precautions).
2. Disconnect the battery.
*
Disconnect the ground clamp from negative battery terminal.
*
Loosen the nut.
3. Loosen the nuts on the right rear wheel
4. Raise the vehicle halfway.
5. Remove the right rear wheel.
6. Remove the right rear wheel housing inner panel.
*
Remove the 2 nuts (1)
*
Remove the 2 bolts (2)
