saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Evaporative Emissions Hose|Service and Repair|Page 4619 > < Evaporative Emission Canister Vent Solenoid Valve Solenoid Wiring Harness Replacement|Page 4615
Page 1
background image

Evaporative Emissions Hose: Service and Repair

Fuel Tank Filler Evaporative Emission Pipe Replacement

Removal Procedure

Warning:  Refer to Gasoline/Gasoline Vapors Warning   (See: Fuel Delivery and Air Induction/Fuel/Service Precautions).

Note:  
*

The fuel tank must be drained with a suitable, commercially-available fuel removal unit and suction hose - follow safety regulations and
national legislation. The fuel tank is fitted with a refill limit float valve. This is located on the filler neck in the fuel tank. To prevent damaging
the refill limit float valve, a suitable suction hose must be used. 

*

In the presence of fuel vapors or escaping fuel - observe safety regulations and national legislation. Store drained fuel in a suitable, sealable
container.

1. Open the hood.

Warning:  Refer to Battery Disconnect Warning   (See: Starting and Charging/Battery/Service Precautions).

2. Disconnect the battery.

1. Disconnect the ground clamp from the ground terminal. 
2. Loosen the nut.

3. Raise the vehicle all the way. 

Evaporative Emissions Hose|Service and Repair|Page 4619 > < Evaporative Emission Canister Vent Solenoid Valve Solenoid Wiring Harness Replacement|Page 4615