Astra L4-1.8L (2009)
7. Adjust the selector lever position switch, if necessary.
*
Release the 2 nuts (2 and 4).
*
Twist the selector lever position switch.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Fasten the selector lever position switch.
Tighten the 2 bolts (1, 3) to 25 Nm (18 lb ft).
2. Inspect the setting of the selector lever position switch.
Note: The light diodes corresponding to the markings on the insert module must flash for each individual gear. Use plug-in check-display (4) for
"AF TYPE" (arrow).