Astra L4-1.8L (2009)
Installation Procedure
1. Use a touch-up pen matching the color of the vehicle to repair any paint damage.
2. Install the 6 fastening clips.
Install the fastening clips.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the new roof side rail restraint module.
Tighten the 8 screws to 1.5 Nm (13 lb in).
Connect and latch the wiring harness plug.
4. Install the headlining trim panel. Refer to Headlining Trim Panel Replacement (Sedan) (See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair)Headlining Trim Panel Replacement (With Sunroof) (See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair)Headlining Trim Panel Replacement (Coupe) (See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair).
Note: After ignition ON, the roof side rail module system readiness indicator illuminates for 4 seconds and then goes out.
5. Readiness indicator.
Inflatable Restraint Roof Side Rail Module Replacement (Sedan Replacement)
Roof Side Rail Inflatable Restraint Module Replacement (Sedan Replacement)
Removal Procedure
Warning: Refer to SIR Inflator Module Handling and Storage Warning (See: Service Precautions/SIR Inflator Module Handling and
Storage Warning).
Warning
In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side
impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.
1. Remove the headlining trim panel. Refer to Headlining Trim Panel Replacement (Sedan) (See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair)Headlining Trim Panel Replacement (With Sunroof) (See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair)Headlining Trim Panel Replacement (Coupe) (See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair).
