Astra L4-1.8L (2009)
Note: If the vehicle is equipped with dual stage air bags the steering wheel module and I/P module will each have 4 wires. Refer to Component
Connector End Views (See: Diagrams/Connector Views) for determining high and low circuits.
6. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
7. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
8. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. Use these wires to fabricate the driver deployment
harness.
9. Strip 13 mm (0.5 in) of insulation from both ends of the wires.
10. Twist together one end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until you are ready to deploy the inflator module.
11. Twist together the 2 connector wire leads from the high circuits from both stages of the steering wheel module, to one set of deployment wires.
Refer to Component Connector End Views (See: Diagrams/Connector Views) in order to determine the correct circuits.
12. Inspect that the 3-wire connection is secure.
13. Secure and insulate the 3-wire connection to the deployment harness using electrical tape.