Astra L4-1.8L (2009)
*
Remove the 2 bolts (1).
*
Disconnect the wiring harness plug and remove the sensor.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the airbag sensor.
Insert the sensor and connect the wiring harness plug.
Tighten the 2 bolts to 6 Nm (53 lb in).
2. Install the battery.
3. Connect the battery.
Tighten the bolt to 5 Nm (44 lb in).
4. Perform the readiness inspection.
5. For programming procedures, refer to Control Module References (See: Testing and Inspection/Programming and Relearning).