saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Ball Joint > < Axle Beam|Service and Repair|Page 9334
Page 7
background image

Tighten the 2 bolts to 130 Nm (96 lb ft).

14. Lower the hydraulic lift table and remove. 

15. Attach the handbrake cable to the brake caliper. 

*

Insert the 2 handbrake cables into the bracket on the brake caliper.

*

Attach the 2 retaining clips (2) to handbrake cable.

*

Push down the 2 operating levers (1) at brake caliper with a screwdriver.

*

Attach the 2 handbrake cables.

16. Reattach parking brake cables to retaining brackets.
17. Reconnect the restraining brackets holding the wheel speed sensor wires and service brake hoses to the rear axle.
18. Install the rear wheels. Refer to Tire and Wheel Removal and Installation   (See: Wheels and Tires/Service and Repair).
19. Lower the vehicle.
20. Adjust the handbrake. Refer to Parking Brake Adjustment   (See: Brakes and Traction Control/Parking Brake System/Adjustments).

Ball Joint > < Axle Beam|Service and Repair|Page 9334