saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

A/T - Oil Cooler Line Torque Procedure|Page 6211 > < Fluid - A/T|Capacity Specifications|Page 6206
Page 1
background image

Fluid Line/Hose: Technical Service Bulletins
A/T - Oil Cooler Line Torque Procedure

INFORMATION

Bulletin No.: 08-07-30-045

Date: October 27, 2008

Subject: 
Information on Aisin(R) AF 17-4 Automatic Transmission (RPO MNF) Oil Cooler Line Torque Procedure at Radiator

Models:
2008-2009 Saturn Astra

with 1.8L I-4 Engine (VIN 1 - RPO 2H0)
and Equipped with Aisin(R) AF 17-4 Automatic Transmission (RPO MNF)

Attention:

The specified torque procedure in this bulletin should be followed when installing the transmission oil cooler lines to the radiator. The
over-tightening of the oil cooler bolts to the radiator may cause internal damage to the inner transmission oil cooler tank inside the radiator. If the
internal oil cooler tank in the radiator becomes damaged, engine coolant may leak into the transmission.

The purpose of this bulletin is to inform retailers on the importance of not over-tightening the upper or lower automatic transmission oil cooler lines at
the radiator. The oil cooler line connections at the radiator should be handled with care during installation. Refer to Transmission Fluid Cooler
Hose/Pipe Replacement or Radiator Replacement in SI. 

Aisin(R) AF 17-4 Automatic Transmission (RPO MNF) Oil Cooler Line Torque Procedure at Radiator

Caution:

DO NOT over-tighten the transmission oil cooler line bolts at the radiator or damage may occur to the internal oil cooler tank inside the
radiator.

The oil cooler line connections at the radiator should be tightened using the steps below.

1.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in SI.

A/T - Oil Cooler Line Torque Procedure|Page 6211 > < Fluid - A/T|Capacity Specifications|Page 6206