Astra L4-1.8L (2009)
14. Remove the engine mount bracket (1).
*
Clamp in the vice.
*
Remove the bolt.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the bracket to the engine mount.
Tighten the bolt to 55 Nm (40 lb ft).
2. Remove the engine mount from the vice.
3. Install the engine mount to the longitudinal beam.
Tighten the 4 bolts to 55 Nm (40 lb ft).
*
Install the clutch pressure line.
*
Install the 2x in bracket.
4. Install the left-hand engine mount support.
*
Install the engine mount bracket to the transmission.
Tighten the 3 bolts to 35 Nm (26 lb ft).
*
Install to the engine mount bracket.
Tighten the 3 bolts to 55 Nm (40 lb ft).
5. Raise the vehicle by its full height.
6. Install the engine mount to the longitudinal beam.
*
Tighten the bolt to 20 Nm (15 lb ft).
*
Tighten the nut to 20 Nm (15 lb ft).
7. Fasten the paneling, wheel housing.
Install the body-bound rivet.
8. Remove the KM-6173.
Remove the 4 bolts.
