Astra L4-1.8L (2009)
7. Remove the clutch master cylinder.
*
Remove the footwell trim on the driver side.
*
Disconnect the return spring (5).
*
Remove pin in the pedal (3).
-
Open the lock tab (4) with a screwdriver.
-
Remove the retaining plate from the pedal pin.
*
Remove the nuts (2) and (6) from the pedal support.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: Use new nuts.
1. Install the clutch master cylinder.
*
Install the clutch master cylinder in bulkhead.
*
Install the clutch master cylinder to the pedal support.
Tighten the nuts (2) and (6) to 20 Nm (15 lb ft).
*
Install the pedal pin (3)
-
Connect the lock tab to the pedal pin.
-
Bend the retaining plate (4) together.
*
Install the return spring (5).
*
Install the driver side footwell trim.
